Bang & Olufsen BeoLab 10 Instrukcja Użytkownika Pobierz pdf (Strona 3)

Daily use

When you have ﬁnished setting

up the loudspeaker as

described on the following

pages, connect the entire

system to the mains.

Loudspeaker protection

The loudspeaker is equipped with a

thermal protection system which

prevents damage from overheating.

If an error occurs – or the speaker

units become overheated – the

system automatically switches the

loudspeaker to standby.

To restore the sound:

> Disconnect the loudspeaker from

the mains supply.

> Allow the system time to reset or

cool down (approximately 3–5

minutes).

> Reconnect the loudspeaker to

the mains supply.

Should the problem persist,

contact your Bang & Olufsen

retailer.

To clean the loudspeaker

Clean dusty surfaces using a dry,

soft cloth. If necessary, remove

grease stains or persistent dirt with

a lint-free, ﬁrmly wrung cloth,

dipped in a solution of water

containing only a few drops of

mild detergent, such as washing-

up liquid.

Never use a vacuum cleaner to

clean the exposed speaker

membrane in the acoustic lens.

However, the loudspeaker front

cloth may be cleaned with a

vacuum cleaner with a soft brush

nozzle, and set to the lowest level.

Never use alcohol or other solvents

to clean any parts of the loud-

speaker!

To switch on and off

When you switch on your Bang &

Olufsen system, the loudspeaker

switches on simultaneously, and

when you switch the system off

again, the loudspeaker also

switches to standby.

Caution: Do not touch the

exposed speaker membrane in the

acoustic lens!

!

3

1 2 3 4 5 6 7 8 ... 11 12

Komentarze do niniejszej Instrukcji

Brak uwag